Procedure Lumbar Facet Joint RF Treatment

Position and anatomical landmarks

The patient lies in the prone position on the operating table with a pillow under the abdomen to flatten the lumbar lordosis. If necessary, sedation should be light in order to enable communication with the patient. Firstly, the anatomical structures are identified with an anterior posterior view. Next, the C-arm is rotated axially to align the X-ray beam parallel with the L4-L5 disc in order to remove parallax of the end plates. The C-arm is then rotated approximately 15° obliquely to the ipsilateral side so that the junction between the superior articular process and the transverse process, the traditional target point, is more easily accessible. Then, the insertion place is marked on the skin. The target is the cephalad junction between the superior articular process and the transverse process.


A 22-G 10 cm with a 5-mm active tip is used.  In RF treatments of the medial branch, contact should first be made with the transverse process, as close as possible to the superior articular process. After contacting bone, the needle is advanced slightly in a cranial direction so that its tip slides over the transverse process (Figure 1).


Figure 1. RF treatment of dorsal branches of facet joints L3, L4, and L5: oblique view.

In the lateral fluoroscopic view, the electrode tip should now lie at the base of the superior articular process in the plane formed by the so-called facet column at the lower aspect of the intervertebral foramen, approximately 1 mm dorsal to its posterior border (Figure 2).

Figure 2. RF treatment of dorsal branches of facet joints L3, L4, and L5: lateral view.

When the correct needle position is confirmed in multiple views, the impedance is checked and a sensory stimulus current of 50 Hz applied. The electrode position is generally deemed adequate if concordant stimulation is obtained at 0.5 V. Motor stimulations at 2 Hz serve to confirm correct needle placement via contraction of the multifidus muscles. In case of improper placement, distal muscle contractions occur in the legs. Although not always detectable, local muscle contractions in the back can generally be observed and palpated by the pain specialist. If leg movement is observed or if the patient feels contractions in the leg, the needle must be repositioned. When the needle is properly positioned, 0.5 ml of local anaesthetic is injected. After a brief interval, during which the local anaesthetic becomes effective, a lesion of 22V and 67°C is applied for at least one minute.

The nerve location and technique are the same for the medial branch of nerves L1-L4. For L5, it is the dorsal branch itself that is amenable to RF treatment, as it courses along the junction between the ala and articular process of the sacral bone. At level L5, stimulation with 2 Hz does not always produce prominent contractions of the multifidus muscles. Yet, motor stimulation should be performed in order to prevent inadvertent lesions too close in proximity to the segmental nerve.


  • The most serious complication after the injection is infection.
  • Small subcutaneous bleedings may result in a temporary increase in pain after the injection.
  • Burning local pain.
  • Temporary paresis due to overflow of local anesthetic into the segmental nerves.
Close the survey
This question is for testing whether or not you are a human visitor and to prevent automated spam submissions.